Dynamic Power in CMOS Formula

Fx Copy
LaTeX Copy
The Dynamic Power is calculated during the rise and fall of the input signal. These are smaller then the dynamic power dissipation. Check FAQs
Pdyn=Psc+Ps
Pdyn - Dynamic Power?Psc - Short-Circuit Power?Ps - Switching Power?

Dynamic Power in CMOS Example

With values
With units
Only example

Here is how the Dynamic Power in CMOS equation looks like with Values.

Here is how the Dynamic Power in CMOS equation looks like with Units.

Here is how the Dynamic Power in CMOS equation looks like.

46.13Edit=46Edit+0.13Edit
You are here -
HomeIcon Home » Category Engineering » Category Electronics » Category CMOS Design and Applications » fx Dynamic Power in CMOS

Dynamic Power in CMOS Solution

Follow our step by step solution on how to calculate Dynamic Power in CMOS?

FIRST Step Consider the formula
Pdyn=Psc+Ps
Next Step Substitute values of Variables
Pdyn=46mW+0.13mW
Next Step Convert Units
Pdyn=0.046W+0.0001W
Next Step Prepare to Evaluate
Pdyn=0.046+0.0001
Next Step Evaluate
Pdyn=0.04613W
LAST Step Convert to Output's Unit
Pdyn=46.13mW

Dynamic Power in CMOS Formula Elements

Variables
Dynamic Power
The Dynamic Power is calculated during the rise and fall of the input signal. These are smaller then the dynamic power dissipation.
Symbol: Pdyn
Measurement: PowerUnit: mW
Note: Value should be greater than 0.
Short-Circuit Power
Short-Circuit Power is defined as the theoretical current that will run in the event of a short circuit if the protection has not yet intervened.
Symbol: Psc
Measurement: PowerUnit: mW
Note: Value should be greater than 0.
Switching Power
Switching Power is called the dynamic power because it arises from the switching of the load.
Symbol: Ps
Measurement: PowerUnit: mW
Note: Value should be greater than 0.

Other formulas in CMOS Power Metrics category

​Go Activity Factor
α=PsCVbc2f
​Go Switching Power
Ps=α(CVbc2f)
​Go Short-Circuit Power in CMOS
Psc=Pdyn-Ps
​Go Static Power in CMOS
Pst=Pt-Pdyn

How to Evaluate Dynamic Power in CMOS?

Dynamic Power in CMOS evaluator uses Dynamic Power = Short-Circuit Power+Switching Power to evaluate the Dynamic Power, The Dynamic Power in CMOS formula is calculated during the rise and fall of the input signal. These are smaller then the dynamic power dissipation. This is solely due to the energy required to charge and discharge the load capacitances. Dynamic Power is denoted by Pdyn symbol.

How to evaluate Dynamic Power in CMOS using this online evaluator? To use this online evaluator for Dynamic Power in CMOS, enter Short-Circuit Power (Psc) & Switching Power (Ps) and hit the calculate button.

FAQs on Dynamic Power in CMOS

What is the formula to find Dynamic Power in CMOS?
The formula of Dynamic Power in CMOS is expressed as Dynamic Power = Short-Circuit Power+Switching Power. Here is an example- 46130 = 0.046+0.00013.
How to calculate Dynamic Power in CMOS?
With Short-Circuit Power (Psc) & Switching Power (Ps) we can find Dynamic Power in CMOS using the formula - Dynamic Power = Short-Circuit Power+Switching Power.
Can the Dynamic Power in CMOS be negative?
No, the Dynamic Power in CMOS, measured in Power cannot be negative.
Which unit is used to measure Dynamic Power in CMOS?
Dynamic Power in CMOS is usually measured using the Milliwatt[mW] for Power. Watt[mW], Kilowatt[mW], Microwatt[mW] are the few other units in which Dynamic Power in CMOS can be measured.
Copied!