FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Engineering
»
Civil
»
Hydraulics and Waterworks
Width of Trapezoidal Channel Section in Hydraulics and Waterworks Formulas
Width of Trapezoidal Channel Section is the horizontal distance between its parallel sides or banks. And is denoted by B. Width of Trapezoidal Channel Section is usually measured using the Millimeter for Length. Note that the value of Width of Trapezoidal Channel Section is always negative. Typically, the value of Width of Trapezoidal Channel Section is greater than 0.
Hydraulics and Waterworks formulas that make use of Width of Trapezoidal Channel Section
f
x
Wetted Area of Trapezoidal Channel Section
Go
f
x
Wetted Perimeter of Trapezoidal Channel Section
Go
f
x
Hydraulic Radius of Trapezoidal Channel Section
Go
FAQ
What is the Width of Trapezoidal Channel Section?
Width of Trapezoidal Channel Section is the horizontal distance between its parallel sides or banks. Width of Trapezoidal Channel Section is usually measured using the Millimeter for Length. Note that the value of Width of Trapezoidal Channel Section is always negative. Typically, the value of Width of Trapezoidal Channel Section is greater than 0.
Can the Width of Trapezoidal Channel Section be negative?
Yes, the Width of Trapezoidal Channel Section, measured in Length can be negative.
What unit is used to measure Width of Trapezoidal Channel Section?
Width of Trapezoidal Channel Section is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Width of Trapezoidal Channel Section can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!