WAS Pumping Rate from Return Line in Substrate Concentration Formulas

WAS Pumping Rate from Return Line is the flow rate of waste sludge from the return line. And is denoted by Q_w'. WAS Pumping Rate from Return Line is usually measured using the Cubic Meter per Day for Volumetric Flow Rate. Note that the value of WAS Pumping Rate from Return Line is always positive. Typically, the value of WAS Pumping Rate from Return Line is greater than 0.

Substrate Concentration formulas that make use of WAS Pumping Rate from Return Line

fxConcentration of Sludge in Return Line given Wasting Rate from Return LineGo

fxConcentration of Solids in Effluent given Wasting Rate from Return LineGo

fxConcentration of Sludge in Return Line given RAS Pumping Rate from Aeration TankGo

fxEffluent Flow Rate given Wasting Rate from Return LineGo

FAQ

What is the WAS Pumping Rate from Return Line?

WAS Pumping Rate from Return Line is the flow rate of waste sludge from the return line. WAS Pumping Rate from Return Line is usually measured using the Cubic Meter per Day for Volumetric Flow Rate. Note that the value of WAS Pumping Rate from Return Line is always positive. Typically, the value of WAS Pumping Rate from Return Line is greater than 0.

Can the WAS Pumping Rate from Return Line be negative?

No, the WAS Pumping Rate from Return Line, measured in Volumetric Flow Rate cannot be negative.

What unit is used to measure WAS Pumping Rate from Return Line?

WAS Pumping Rate from Return Line is usually measured using the Cubic Meter per Day[m³/d] for Volumetric Flow Rate. Cubic Meter per Second[m³/d], Cubic Meter per Hour[m³/d], Cubic Meter per Minute[m³/d] are the few other units in which WAS Pumping Rate from Return Line can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!