Vaporisation Energy of Material in Laser Beam Machining (LBM) Formulas

Vaporisation Energy of Material is the energy required to turn the material into vapor. And is denoted by E. Vaporisation Energy of Material is usually measured using the Watt Per Cubic Millimeter for Power Density. Note that the value of Vaporisation Energy of Material is always positive.

Formulas to find Vaporisation Energy of Material in Laser Beam Machining (LBM)

fxVaporisation Energy of MaterialGo

Laser Beam Machining (LBM) formulas that make use of Vaporisation Energy of Material

fxCutting RateGo

fxConstant Dependent of MaterialGo

fxLaser Power Incident on SurfaceGo

fxArea of Laser Beam at Focal PointGo

fxThickness of MaterialGo

List of variables in Laser Beam Machining (LBM) formulas

fx Empirical Constant Go

fx Laser Energy during Cut Rate Go

fx Cutting Rate Go

fx Laser Beam Area at Focal Point Go

fx Thickness Go

FAQ

What is the Vaporisation Energy of Material?

Vaporisation Energy of Material is the energy required to turn the material into vapor. Vaporisation Energy of Material is usually measured using the Watt Per Cubic Millimeter for Power Density. Note that the value of Vaporisation Energy of Material is always positive.

Can the Vaporisation Energy of Material be negative?

No, the Vaporisation Energy of Material, measured in Power Density cannot be negative.

What unit is used to measure Vaporisation Energy of Material?

Vaporisation Energy of Material is usually measured using the Watt Per Cubic Millimeter[W/mm³] for Power Density. Horsepower Per Litre[W/mm³], Decawatt Per Cubic Meter[W/mm³], Gigawatt Per Cubic Meter[W/mm³] are the few other units in which Vaporisation Energy of Material can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!