Transition Width in Opto Electronics Devices Formulas

Transition width is defined as when the drain-to-source voltage increases, the triode region transitions to the saturation region. And is denoted by W. Transition Width is usually measured using the Micrometer for Length. Note that the value of Transition Width is always positive.

Opto Electronics Devices formulas that make use of Transition Width

fxCurrent Due to Optically Generated CarrierGo

fxDiffusion Length of Transition RegionGo

FAQ

What is the Transition Width?

Transition width is defined as when the drain-to-source voltage increases, the triode region transitions to the saturation region. Transition Width is usually measured using the Micrometer for Length. Note that the value of Transition Width is always positive.

Can the Transition Width be negative?

No, the Transition Width, measured in Length cannot be negative.

What unit is used to measure Transition Width?

Transition Width is usually measured using the Micrometer[μm] for Length. Meter[μm], Millimeter[μm], Kilometer[μm] are the few other units in which Transition Width can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!