Thickness of Stock in Sheet Metal Operations Formulas

Thickness of Stock generally refers to the initial thickness of raw material or stock material before any machining or processing takes place. And is denoted by t_stk. Thickness of Stock is usually measured using the Millimeter for Length. Note that the value of Thickness of Stock is always positive.

Formulas to find Thickness of Stock in Sheet Metal Operations

fxStock Thickness used in Bending OperationGo

fxStock Thickness when Shear used on PunchGo

Sheet Metal Operations formulas that make use of Thickness of Stock

fxLength of Bent Part in Bending OperationGo

fxShear on Punch or DieGo

fxMaximum Shear Force given Shear Applied to Punch or DieGo

fxPenetration of Punch as FractionGo

fxPerimeter of Cut when Shear is AppliedGo

List of variables in Sheet Metal Operations formulas

fx Bending Force Go

fx Width between Contact Points Go

fx Bending Die Constant Go

fx Bent Part Length Go

fx Ultimate Tensile Strength Go

fx Maximum Shear Force Go

fx Shear on Punch Go

fx Cutting Perimeter Go

fx Punch Penetration Go

FAQ

What is the Thickness of Stock?

Thickness of Stock generally refers to the initial thickness of raw material or stock material before any machining or processing takes place. Thickness of Stock is usually measured using the Millimeter for Length. Note that the value of Thickness of Stock is always positive.

Can the Thickness of Stock be negative?

No, the Thickness of Stock, measured in Length cannot be negative.

What unit is used to measure Thickness of Stock?

Thickness of Stock is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Thickness of Stock can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!