Thickness at given Point in Rolling Process Formulas

Thickness at given Point is defined as the thickness of stock at any point between entry and neutral point during the rolling. And is denoted by h_s. Thickness at given Point is usually measured using the Millimeter for Length. Note that the value of Thickness at given Point is always positive.

Rolling Process formulas that make use of Thickness at given Point

fxInitial Stock Thickness given Pressure on RollsGo

FAQ

What is the Thickness at given Point?

Thickness at given Point is defined as the thickness of stock at any point between entry and neutral point during the rolling. Thickness at given Point is usually measured using the Millimeter for Length. Note that the value of Thickness at given Point is always positive.

Can the Thickness at given Point be negative?

No, the Thickness at given Point, measured in Length cannot be negative.

What unit is used to measure Thickness at given Point?

Thickness at given Point is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Thickness at given Point can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!