FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Engineering
»
Electrical
»
Power System
Theta in 3 Wire System Formulas
Theta is an angle that can be defined as the figure formed by two rays meeting at a common endpoint. And is denoted by θ. Theta is usually measured using the Degree for Angle. Note that the value of Theta is always negative.
3 Wire System formulas that make use of Theta
f
x
Maximum Voltage using Volume of Conductor Material (3-Phase 3-Wire US)
Go
f
x
Load Current Per Phase (3-Phase 3-Wire US)
Go
f
x
Maximum Voltage using Load Current Per Phase (3-Phase 3-Wire US)
Go
f
x
RMS Voltage using Load Current Per Phase (3-Phase 3-Wire US)
Go
f
x
Maximum Voltage using Area of X-Section (3-Phase 3-Wire US)
Go
f
x
RMS Voltage using Area of X-Section (3-Phase 3-Wire US)
Go
FAQ
What is the Theta?
Theta is an angle that can be defined as the figure formed by two rays meeting at a common endpoint. Theta is usually measured using the Degree for Angle. Note that the value of Theta is always negative.
Can the Theta be negative?
Yes, the Theta, measured in Angle can be negative.
What unit is used to measure Theta?
Theta is usually measured using the Degree[°] for Angle. Radian[°], Minute[°], Second[°] are the few other units in which Theta can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!