Rate based on Volume of Contactor in Non Catalytic Systems Formulas

Rate based on Volume of Contactor refers to the Rate Calculated when Unit Volume of Contactor is Considered. And is denoted by r''''_A. Rate based on Volume of Contactor is usually measured using the Mole per Cubic Meter Second for Reaction Rate. Note that the value of Rate based on Volume of Contactor is always negative. Typically, the value of Rate based on Volume of Contactor is greater than -999.

Formulas to find Rate based on Volume of Contactor in Non Catalytic Systems

fxGeneral Rate Equation of Mass TransferGo

List of variables in Non Catalytic Systems formulas

fx Gas Phase Mass Transfer Coefficient Go

fx Interfacial Area using Contactor Go

fx Henry Law Constant Go

fx Liquid Phase Mass Transfer Coefficient Go

fx Liquid Film Enhancement Factor Go

fx Rate Constant for Fluid Fluid Reactions Go

fx Fraction of Liquid Go

fx Concentration of Liquid B Go

fx Partial Pressure of Reactant A Go

FAQ

What is the Rate based on Volume of Contactor?

Rate based on Volume of Contactor refers to the Rate Calculated when Unit Volume of Contactor is Considered. Rate based on Volume of Contactor is usually measured using the Mole per Cubic Meter Second for Reaction Rate. Note that the value of Rate based on Volume of Contactor is always negative. Typically, the value of Rate based on Volume of Contactor is greater than -999.

Can the Rate based on Volume of Contactor be negative?

Yes, the Rate based on Volume of Contactor, measured in Reaction Rate can be negative.

What unit is used to measure Rate based on Volume of Contactor?

Rate based on Volume of Contactor is usually measured using the Mole per Cubic Meter Second[mol/m³*s] for Reaction Rate. Mole per Liter Second[mol/m³*s], Millimole per Liter Second[mol/m³*s] are the few other units in which Rate based on Volume of Contactor can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!