Radius of the Electrodes in Electro Discharge Machining (EDM) Formulas

Radius of the electrodes is defined as the radius of the electrode used for unconventional machining by EDM. And is denoted by R₀. Radius of the Electrodes is usually measured using the Centimeter for Length. Note that the value of Radius of the Electrodes is always negative.

Formulas to find Radius of the Electrodes in Electro Discharge Machining (EDM)

fxRadius of electrode from pressure flushing holeGo

Electro Discharge Machining (EDM) formulas that make use of Radius of the Electrodes

fxPressure distribution in flushing gapGo

fxRadius of flushing hole EDMGo

fxAtmospheric pressure at electrode tipGo

fxPressure in flushing holeGo

fxRadial location of pressure distributionGo

List of variables in Electro Discharge Machining (EDM) formulas

fx Radial Location of Pressure Go

fx Pressure in Flushing Hole Go

fx Atmospheric Pressure Go

fx Pressure in the Flushing Gap Go

fx Radius of Flushing Hole Go

FAQ

What is the Radius of the Electrodes?

Radius of the electrodes is defined as the radius of the electrode used for unconventional machining by EDM. Radius of the Electrodes is usually measured using the Centimeter for Length. Note that the value of Radius of the Electrodes is always negative.

Can the Radius of the Electrodes be negative?

Yes, the Radius of the Electrodes, measured in Length can be negative.

What unit is used to measure Radius of the Electrodes?

Radius of the Electrodes is usually measured using the Centimeter[cm] for Length. Meter[cm], Millimeter[cm], Kilometer[cm] are the few other units in which Radius of the Electrodes can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!