Radius of Flushing Hole in Electro Discharge Machining (EDM) Formulas

Radius of flushing hole is the radius of flushing hole in EDM. And is denoted by R₁. Radius of Flushing Hole is usually measured using the Centimeter for Length. Note that the value of Radius of Flushing Hole is always positive.

Formulas to find Radius of Flushing Hole in Electro Discharge Machining (EDM)

fxRadius of flushing holeGo

Electro Discharge Machining (EDM) formulas that make use of Radius of Flushing Hole

fxFlow rate of electrolyteGo

fxGap spacingGo

fxDynamic viscosity of electrolyteGo

fxPressure in flushing hole flow rate electrolyteGo

fxAtmospheric pressureGo

fxRadius of electrodeGo

List of variables in Electro Discharge Machining (EDM) formulas

fx Radius of the Electrodes Go

fx Pressure in Flushing Hole Go

fx Atmospheric Pressure Go

fx Gap Spacing Go

fx Flow Rate of the Electrolyte Go

fx Dynamic Viscosity Go

FAQ

What is the Radius of Flushing Hole?

Radius of flushing hole is the radius of flushing hole in EDM. Radius of Flushing Hole is usually measured using the Centimeter for Length. Note that the value of Radius of Flushing Hole is always positive.

Can the Radius of Flushing Hole be negative?

No, the Radius of Flushing Hole, measured in Length cannot be negative.

What unit is used to measure Radius of Flushing Hole?

Radius of Flushing Hole is usually measured using the Centimeter[cm] for Length. Meter[cm], Millimeter[cm], Kilometer[cm] are the few other units in which Radius of Flushing Hole can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!