Radius of Flushing Hole in Electro Discharge Machining (EDM) Formulas

Radius of flushing hole is the radius of flushing hole in EDM. And is denoted by R₁. Radius of Flushing Hole is usually measured using the Centimeter for Length. Note that the value of Radius of Flushing Hole is always positive.

Electro Discharge Machining (EDM) formulas that make use of Radius of Flushing Hole

fxNet force acting on electrodeGo

fxPressure in flushing hole net force electrodeGo

fxAmbient atmospheric pressureGo

FAQ

What is the Radius of Flushing Hole?

Radius of flushing hole is the radius of flushing hole in EDM. Radius of Flushing Hole is usually measured using the Centimeter for Length. Note that the value of Radius of Flushing Hole is always positive.

Can the Radius of Flushing Hole be negative?

No, the Radius of Flushing Hole, measured in Length cannot be negative.

What unit is used to measure Radius of Flushing Hole?

Radius of Flushing Hole is usually measured using the Centimeter[cm] for Length. Meter[cm], Millimeter[cm], Kilometer[cm] are the few other units in which Radius of Flushing Hole can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!