Pressure in Flushing Hole in Electro Discharge Machining (EDM) Formulas

Pressure in Flushing Hole is the pressure in hole during EDM machining. And is denoted by P₁. Pressure in Flushing Hole is usually measured using the Newton per Square Centimeter for Pressure. Note that the value of Pressure in Flushing Hole is always positive.

Formulas to find Pressure in Flushing Hole in Electro Discharge Machining (EDM)

fxPressure in flushing hole flow rate electrolyteGo

Electro Discharge Machining (EDM) formulas that make use of Pressure in Flushing Hole

fxFlow rate of electrolyteGo

fxGap spacingGo

fxDynamic viscosity of electrolyteGo

fxAtmospheric pressureGo

fxRadius of electrodeGo

fxRadius of flushing holeGo

List of variables in Electro Discharge Machining (EDM) formulas

fx Atmospheric Pressure Go

fx Flow Rate of the Electrolyte Go

fx Dynamic Viscosity Go

fx Radius of the Electrodes Go

fx Radius of Flushing Hole Go

fx Gap Spacing Go

FAQ

What is the Pressure in Flushing Hole?

Pressure in Flushing Hole is the pressure in hole during EDM machining. Pressure in Flushing Hole is usually measured using the Newton per Square Centimeter for Pressure. Note that the value of Pressure in Flushing Hole is always positive.

Can the Pressure in Flushing Hole be negative?

No, the Pressure in Flushing Hole, measured in Pressure cannot be negative.

What unit is used to measure Pressure in Flushing Hole?

Pressure in Flushing Hole is usually measured using the Newton per Square Centimeter[N/cm²] for Pressure. Pascal[N/cm²], Kilopascal[N/cm²], Bar[N/cm²] are the few other units in which Pressure in Flushing Hole can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!