Plowing Force in Metal Machining Dynamics Formulas

The Plowing Force is the force required to overcome this deformation that does not contribute to the chip removal and hence is commonly named plowing force. And is denoted by F_p. Plowing Force is usually measured using the Newton for Force. Note that the value of Plowing Force is always positive.

Metal Machining Dynamics formulas that make use of Plowing Force

fxForce required to remove Chip and Acting on Tool FaceGo

fxResultant Cutting Force using Force required to remove ChipGo

FAQ

What is the Plowing Force?

The Plowing Force is the force required to overcome this deformation that does not contribute to the chip removal and hence is commonly named plowing force. Plowing Force is usually measured using the Newton for Force. Note that the value of Plowing Force is always positive.

Can the Plowing Force be negative?

No, the Plowing Force, measured in Force cannot be negative.

What unit is used to measure Plowing Force?

Plowing Force is usually measured using the Newton[N] for Force. Exanewton[N], Meganewton[N], Kilonewton[N] are the few other units in which Plowing Force can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!