Plastic Section Modulus in Load Factor Design (LFD) Formulas

Plastic Section Modulus is the section modulus for plastic analysis. And is denoted by Z. Plastic Section Modulus is usually measured using the Cubic Millimeter for Volume. Note that the value of Plastic Section Modulus is always positive.

Load Factor Design (LFD) formulas that make use of Plastic Section Modulus

fxMaximum Bending Strength for Symmetrical Flexural Compact Section for LFD of BridgesGo

FAQ

What is the Plastic Section Modulus?

Plastic Section Modulus is the section modulus for plastic analysis. Plastic Section Modulus is usually measured using the Cubic Millimeter for Volume. Note that the value of Plastic Section Modulus is always positive.

Can the Plastic Section Modulus be negative?

No, the Plastic Section Modulus, measured in Volume cannot be negative.

What unit is used to measure Plastic Section Modulus?

Plastic Section Modulus is usually measured using the Cubic Millimeter[mm³] for Volume. Cubic Meter[mm³], Cubic Centimeter[mm³], Liter[mm³] are the few other units in which Plastic Section Modulus can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!