Piezometric Head at Downstream End in Unconfined Flow Formulas

The Piezometric Head at Downstream End refers to the specific measurement of liquid pressure above a vertical datum. And is denoted by h₁. Piezometric Head at Downstream End is usually measured using the Meter for Length. Note that the value of Piezometric Head at Downstream End is always negative.

Unconfined Flow formulas that make use of Piezometric Head at Downstream End

fxDischarge per Unit Width of Aquifer considering PermeabilityGo

fxLength about Discharge per Unit Width of AquiferGo

fxEquation of Head for Unconfined Aquifer on Horizontal Impervious BaseGo

fxEquation for Water DivideGo

fxDischarge per Unit Width of Aquifer at any Location xGo

fxDischarge at Downstream Water Body of CatchmentGo

fxCoefficient of Aquifer Permeability considering Discharge per Unit Width of AquiferGo

FAQ

What is the Piezometric Head at Downstream End?

The Piezometric Head at Downstream End refers to the specific measurement of liquid pressure above a vertical datum. Piezometric Head at Downstream End is usually measured using the Meter for Length. Note that the value of Piezometric Head at Downstream End is always negative.

Can the Piezometric Head at Downstream End be negative?

Yes, the Piezometric Head at Downstream End, measured in Length can be negative.

What unit is used to measure Piezometric Head at Downstream End?

Piezometric Head at Downstream End is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Piezometric Head at Downstream End can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!