Path of Recess in Toothed Gearing Formulas

Path of recess is the portion of the path of contact from the pitch point to the end of contact. And is denoted by P₂. Path of Recess is usually measured using the Millimeter for Length. Note that the value of Path of Recess is always negative. Typically, the value of Path of Recess is greater than 0.

Formulas to find Path of Recess in Toothed Gearing

fxLength of Path of RecessGo

fxMaximum Length of Path of RecessGo

List of variables in Toothed Gearing formulas

fx Radius of Addendum Circle of Pinion Go

fx Radius of Pitch Circle of Pinion Go

fx Pressure Angle of Gear Go

fx Radius of Pitch Circle of Wheel Go

FAQ

What is the Path of Recess?

Path of recess is the portion of the path of contact from the pitch point to the end of contact. Path of Recess is usually measured using the Millimeter for Length. Note that the value of Path of Recess is always negative. Typically, the value of Path of Recess is greater than 0.

Can the Path of Recess be negative?

Yes, the Path of Recess, measured in Length can be negative.

What unit is used to measure Path of Recess?

Path of Recess is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Path of Recess can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!