Overcut Constant A in Possible surface defects in EDM Formulas

Overcut Constant A is an empirical constant used in overcut calculations of EDM, its different for different materials at different voltages passing through it. And is denoted by A. Overcut Constant A is usually measured using the Meter for Length. Note that the value of Overcut Constant A is always positive.

Formulas to find Overcut Constant A in Possible surface defects in EDM

fxOvercut constant AGo

Possible surface defects in EDM formulas that make use of Overcut Constant A

fxOvercut produced per sideGo

fxCapacitance responsible for given overcutGo

fxOvercut constant BGo

List of variables in Possible surface defects in EDM formulas

fx Overcut in mm per side Go

fx Overcut Constant B Go

fx Capacitance in Surface Defect Go

FAQ

What is the Overcut Constant A?

Overcut Constant A is an empirical constant used in overcut calculations of EDM, its different for different materials at different voltages passing through it. Overcut Constant A is usually measured using the Meter for Length. Note that the value of Overcut Constant A is always positive.

Can the Overcut Constant A be negative?

No, the Overcut Constant A, measured in Length cannot be negative.

What unit is used to measure Overcut Constant A?

Overcut Constant A is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Overcut Constant A can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!