Negative Sequence Impedance in TCO in Open Conductor Fault Formulas

Negative Sequence Impedance in TCO in open conductor fault is consists of balanced three-phase impedance phasors which are exactly at 120 degrees apart. And is denoted by Z_2(tco). Negative Sequence Impedance in TCO is usually measured using the Ohm for Electric Resistance. Note that the value of Negative Sequence Impedance in TCO is always positive.

Open Conductor Fault formulas that make use of Negative Sequence Impedance in TCO

fxA-Phase EMF using Positive Sequence Current (Two Conductor Open)Go

fxPositive Sequence Impedance using A-Phase EMF (Two Conductor Open)Go

fxPositive Sequence Current using A-Phase EMF (Two Conductor Open)Go

fxNegative Sequence Current using A-Phase Current(Two Conductor Open)Go

fxNegative Sequence Voltage using A-Phase Current(Two Conductor Open)Go

fxNegative Sequence Current using Negative Sequence Voltage (Two Conductor Open)Go

fxNegative Sequence Voltage using Negative Sequence Current (Two Conductor Open)Go

fxZero Sequence Current using A-Phase Current(Two Conductor Open)Go

FAQ

What is the Negative Sequence Impedance in TCO?

Negative Sequence Impedance in TCO in open conductor fault is consists of balanced three-phase impedance phasors which are exactly at 120 degrees apart. Negative Sequence Impedance in TCO is usually measured using the Ohm for Electric Resistance. Note that the value of Negative Sequence Impedance in TCO is always positive.

Can the Negative Sequence Impedance in TCO be negative?

No, the Negative Sequence Impedance in TCO, measured in Electric Resistance cannot be negative.

What unit is used to measure Negative Sequence Impedance in TCO?

Negative Sequence Impedance in TCO is usually measured using the Ohm[Ω] for Electric Resistance. Megohm[Ω], Microhm[Ω], Volt per Ampere[Ω] are the few other units in which Negative Sequence Impedance in TCO can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!