Metal Head at Top Section in Gating System For Casting Formulas

Metal Head at Top Section is the length of molten metal that accumulates at the top of the sprue, which is the vertical passage through which molten metal is poured into a mold during casting. And is denoted by h_t. Metal Head at Top Section is usually measured using the Centimeter for Length. Note that the value of Metal Head at Top Section is always positive.

Formulas to find Metal Head at Top Section in Gating System For Casting

fxMetal Head at Top Section of SprueGo

Gating System For Casting formulas that make use of Metal Head at Top Section

fxArea at Top Section of SprueGo

fxArea at Choke Section of SprueGo

fxMetal Head at Choke Section of SprueGo

List of variables in Gating System For Casting formulas

fx Head at Choke Section Go

fx Area of Sprue in Choke Section Go

fx Area at Top Section Go

FAQ

What is the Metal Head at Top Section?

Metal Head at Top Section is the length of molten metal that accumulates at the top of the sprue, which is the vertical passage through which molten metal is poured into a mold during casting. Metal Head at Top Section is usually measured using the Centimeter for Length. Note that the value of Metal Head at Top Section is always positive.

Can the Metal Head at Top Section be negative?

No, the Metal Head at Top Section, measured in Length cannot be negative.

What unit is used to measure Metal Head at Top Section?

Metal Head at Top Section is usually measured using the Centimeter[cm] for Length. Meter[cm], Millimeter[cm], Kilometer[cm] are the few other units in which Metal Head at Top Section can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!