Maximum Allowable Torsion in Working Stress Design Formulas

Maximum Allowable Torsion in the section is the stress produced in the shaft due to the twisting. And is denoted by T_u. Maximum Allowable Torsion is usually measured using the Megapascal for Pressure. Note that the value of Maximum Allowable Torsion is always negative.

Working Stress Design formulas that make use of Maximum Allowable Torsion

fxSpacing of Closed Stirrups for Torsion under Working Stress DesignGo

FAQ

What is the Maximum Allowable Torsion?

Maximum Allowable Torsion in the section is the stress produced in the shaft due to the twisting. Maximum Allowable Torsion is usually measured using the Megapascal for Pressure. Note that the value of Maximum Allowable Torsion is always negative.

Can the Maximum Allowable Torsion be negative?

Yes, the Maximum Allowable Torsion, measured in Pressure can be negative.

What unit is used to measure Maximum Allowable Torsion?

Maximum Allowable Torsion is usually measured using the Megapascal[MPa] for Pressure. Pascal[MPa], Kilopascal[MPa], Bar[MPa] are the few other units in which Maximum Allowable Torsion can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!