Limiting Size in Base and Bearing Plates Formulas

Limiting Size is the larger value among 0.5(N -0.95d) and 0.5(B -0.80b), where N is the plate length, B is the minimum width of plate, d is the depth of column and b is the width of flange. And is denoted by p. Limiting Size is usually measured using the Millimeter for Length. Note that the value of Limiting Size is always negative.

Base and Bearing Plates formulas that make use of Limiting Size

fxThickness of PlateGo

fxBearing Pressure given Plate ThicknessGo

FAQ

What is the Limiting Size?

Limiting Size is the larger value among 0.5(N -0.95d) and 0.5(B -0.80b), where N is the plate length, B is the minimum width of plate, d is the depth of column and b is the width of flange. Limiting Size is usually measured using the Millimeter for Length. Note that the value of Limiting Size is always negative.

Can the Limiting Size be negative?

Yes, the Limiting Size, measured in Length can be negative.

What unit is used to measure Limiting Size?

Limiting Size is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Limiting Size can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!