Length of Sleeve Arm of Lever in Governors Formulas

Length of Sleeve Arm of Lever is the distance from the pivot point to the point where the sleeve arm of the governor intersects. And is denoted by y. Length of Sleeve Arm of Lever is usually measured using the Meter for Length. Note that the value of Length of Sleeve Arm of Lever is always negative. Typically, the value of Length of Sleeve Arm of Lever is greater than 0.

Governors formulas that make use of Length of Sleeve Arm of Lever

fxCorresponding Radial Force Required at Each Ball for Spring Loaded GovernorsGo

FAQ

What is the Length of Sleeve Arm of Lever?

Length of Sleeve Arm of Lever is the distance from the pivot point to the point where the sleeve arm of the governor intersects. Length of Sleeve Arm of Lever is usually measured using the Meter for Length. Note that the value of Length of Sleeve Arm of Lever is always negative. Typically, the value of Length of Sleeve Arm of Lever is greater than 0.

Can the Length of Sleeve Arm of Lever be negative?

Yes, the Length of Sleeve Arm of Lever, measured in Length can be negative.

What unit is used to measure Length of Sleeve Arm of Lever?

Length of Sleeve Arm of Lever is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Length of Sleeve Arm of Lever can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!