Length of Ball Arm of Lever in Governors Formulas

Length of Ball Arm of Lever is the distance from the axis of rotation to the point where the centrifugal force is applied. And is denoted by x_{ball arm}. Length of Ball Arm of Lever is usually measured using the Meter for Length. Note that the value of Length of Ball Arm of Lever is always negative. Typically, the value of Length of Ball Arm of Lever is greater than 0.

Governors formulas that make use of Length of Ball Arm of Lever

fxCentrifugal Force at Maximum Equilibrium Speed on Each Ball for Wilson-Hartnell GovernorGo

fxCentrifugal Force at Minimum Equilibrium Speed on Each Ball for Wilson-Hartnell GovernorGo

fxCentrifugal Force for Hartung GovernorGo

fxCentrifugal Force on Each Ball for Wilson-Hartnell GovernorGo

FAQ

What is the Length of Ball Arm of Lever?

Length of Ball Arm of Lever is the distance from the axis of rotation to the point where the centrifugal force is applied. Length of Ball Arm of Lever is usually measured using the Meter for Length. Note that the value of Length of Ball Arm of Lever is always negative. Typically, the value of Length of Ball Arm of Lever is greater than 0.

Can the Length of Ball Arm of Lever be negative?

Yes, the Length of Ball Arm of Lever, measured in Length can be negative.

What unit is used to measure Length of Ball Arm of Lever?

Length of Ball Arm of Lever is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Length of Ball Arm of Lever can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!