FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Engineering
»
Civil
»
Timber Engineering
Least Dimension in Laboratory Recommendations, Roof Slope and Oblique Plane Formulas
Least Dimension is the measure of the shortest side of the column. And is denoted by d. Least Dimension is usually measured using the Millimeter for Length. Note that the value of Least Dimension is always positive.
Laboratory Recommendations, Roof Slope and Oblique Plane formulas that make use of Least Dimension
f
x
Allowable Compressive Stress Parallel to Grain for Intermediate Columns
Go
f
x
Allowable Compressive Stress Parallel to Grain for Long Columns
Go
f
x
Allowable Compressive Stress in Rectangular Section
Go
f
x
Elasticity Modulus for Allowable Compressive Stress in Rectangular Section
Go
FAQ
What is the Least Dimension?
Least Dimension is the measure of the shortest side of the column. Least Dimension is usually measured using the Millimeter for Length. Note that the value of Least Dimension is always positive.
Can the Least Dimension be negative?
No, the Least Dimension, measured in Length cannot be negative.
What unit is used to measure Least Dimension?
Least Dimension is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Least Dimension can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!