Impeller Tip Diameter in Components of Gas Turbine Formulas

Impeller Tip Diameter is the distance of the tip from the center of the shaft. And is denoted by D_t. Impeller Tip Diameter is usually measured using the Meter for Length. Note that the value of Impeller Tip Diameter is always positive.

Formulas to find Impeller Tip Diameter in Components of Gas Turbine

fxImpeller Outlet DiameterGo

Components of Gas Turbine formulas that make use of Impeller Tip Diameter

fxMean Diameter of ImpellerGo

fxTip Velocity of Impeller given Hub DiameterGo

List of variables in Components of Gas Turbine formulas

fx Tip Velocity Go

fx RPM Go

FAQ

What is the Impeller Tip Diameter?

Impeller Tip Diameter is the distance of the tip from the center of the shaft. Impeller Tip Diameter is usually measured using the Meter for Length. Note that the value of Impeller Tip Diameter is always positive.

Can the Impeller Tip Diameter be negative?

No, the Impeller Tip Diameter, measured in Length cannot be negative.

What unit is used to measure Impeller Tip Diameter?

Impeller Tip Diameter is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Impeller Tip Diameter can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!