FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Physics
»
Mechanical
»
Heat and Mass Transfer
Height of Crack in Transverse Fin Heat Exchanger Formulas
Height of Crack is the size of a flaw or crack in a material that can lead to catastrophic failure under a given stress. And is denoted by h
c
. Height of Crack is usually measured using the Millimeter for Length. Note that the value of Height of Crack is always positive.
Formulas to find Height of Crack in Transverse Fin Heat Exchanger
f
x
Height of tube tank given convection coefficient
Go
f
x
Height of tank tube given perimeter
Go
Transverse Fin Heat Exchanger formulas that make use of Height of Crack
f
x
Inner diameter of tube given convection coefficient
Go
f
x
Surface area of fin given convection coefficient
Go
f
x
Bare area over fin leaving fin base given convection coefficient
Go
f
x
Convection Coefficient based on Inside Area
Go
f
x
Effective convection coefficient on outside given convection coefficient
Go
f
x
Fin efficiency given convection coefficient
Go
f
x
Mass flux given mass flowrate
Go
f
x
Mass flowrate given mass flux
Go
f
x
Number of tubes in transverse fin heat exchanger
Go
f
x
Bare Area over Fin leaving Fin Base
Go
f
x
Outer Diameter of Tube in Transverse Fin Heat Exchanger
Go
f
x
Perimeter of tube
Go
f
x
Number of fins given perimeter
Go
f
x
Length of fin
Go
List of variables in Transverse Fin Heat Exchanger formulas
f
x
Fin Efficiency
Go
f
x
Surface Area
Go
f
x
Bare Area
Go
f
x
Effective convection coefficient on outside
Go
f
x
Convection coefficient based on inside area
Go
f
x
Inner Diameter
Go
f
x
Perimeter
Go
f
x
Number of Fins
Go
f
x
Fin Length
Go
FAQ
What is the Height of Crack?
Height of Crack is the size of a flaw or crack in a material that can lead to catastrophic failure under a given stress. Height of Crack is usually measured using the Millimeter for Length. Note that the value of Height of Crack is always positive.
Can the Height of Crack be negative?
No, the Height of Crack, measured in Length cannot be negative.
What unit is used to measure Height of Crack?
Height of Crack is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Height of Crack can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!