Head at Choke Section in Gating System For Casting Formulas

Head at Choke Section is the vertical height of molten metal above the narrowest point (choke) in the gating system of a casting, crucial for ensuring proper flow and filling of the mold cavity. And is denoted by h_c. Head at Choke Section is usually measured using the Centimeter for Length. Note that the value of Head at Choke Section is always positive.

Formulas to find Head at Choke Section in Gating System For Casting

fxMetal Head at Choke Section of SprueGo

Gating System For Casting formulas that make use of Head at Choke Section

fxArea at Top Section of SprueGo

fxArea at Choke Section of SprueGo

fxMetal Head at Top Section of SprueGo

List of variables in Gating System For Casting formulas

fx Metal Head at Top Section Go

fx Area at Top Section Go

fx Area of Sprue in Choke Section Go

FAQ

What is the Head at Choke Section?

Head at Choke Section is the vertical height of molten metal above the narrowest point (choke) in the gating system of a casting, crucial for ensuring proper flow and filling of the mold cavity. Head at Choke Section is usually measured using the Centimeter for Length. Note that the value of Head at Choke Section is always positive.

Can the Head at Choke Section be negative?

No, the Head at Choke Section, measured in Length cannot be negative.

What unit is used to measure Head at Choke Section?

Head at Choke Section is usually measured using the Centimeter[cm] for Length. Meter[cm], Millimeter[cm], Kilometer[cm] are the few other units in which Head at Choke Section can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!