Gap between End of Slot to End of Spigot in Design of Cotter Joint Formulas

Gap between End of Slot to End of Spigot is the distance between the end of slot for cotter to the end of spigot opposite from its collar. And is denoted by L_a. Gap between End of Slot to End of Spigot is usually measured using the Millimeter for Length. Note that the value of Gap between End of Slot to End of Spigot is always positive.

Design of Cotter Joint formulas that make use of Gap between End of Slot to End of Spigot

fxShear Stress in Spigot of Cotter Joint given Diameter of Spigot and LoadGo

fxLoad Taken by Spigot of Cotter Joint given Shear Stress in SpigotGo

fxDiameter of Spigot of Cotter Joint given Shear Stress in SpigotGo

FAQ

What is the Gap between End of Slot to End of Spigot?

Gap between End of Slot to End of Spigot is the distance between the end of slot for cotter to the end of spigot opposite from its collar. Gap between End of Slot to End of Spigot is usually measured using the Millimeter for Length. Note that the value of Gap between End of Slot to End of Spigot is always positive.

Can the Gap between End of Slot to End of Spigot be negative?

No, the Gap between End of Slot to End of Spigot, measured in Length cannot be negative.

What unit is used to measure Gap between End of Slot to End of Spigot?

Gap between End of Slot to End of Spigot is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Gap between End of Slot to End of Spigot can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!