Final Thickness in Rolling Process Formulas

Final Thickness is the thickness of the workpiece after rolling. And is denoted by h_ft. Final Thickness is usually measured using the Millimeter for Length. Note that the value of Final Thickness is always positive.

Rolling Process formulas that make use of Final Thickness

fxMean Yield Shear Stress using Pressure on Exit SideGo

fxPressure Acting on Rolls in Exit RegionGo

fxPressure on Rolls given H (Exit Side)Go

fxThickness of Stock at given Point on Exit SideGo

FAQ

What is the Final Thickness?

Final Thickness is the thickness of the workpiece after rolling. Final Thickness is usually measured using the Millimeter for Length. Note that the value of Final Thickness is always positive.

Can the Final Thickness be negative?

No, the Final Thickness, measured in Length cannot be negative.

What unit is used to measure Final Thickness?

Final Thickness is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Final Thickness can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!