Discharge for Partially Penetrating Well in Flow in Wells Formulas

Discharge for Partially Penetrating Well refers to the volume of water extracted from an aquifer when the well does not extend through the entire thickness of the aquifer. And is denoted by Q_v. Discharge for Partially Penetrating Well is usually measured using the Cubic Meter per Second for Volumetric Flow Rate. Note that the value of Discharge for Partially Penetrating Well is always positive.

Formulas to find Discharge for Partially Penetrating Well in Flow in Wells

fxDischarge for Partially Penetrating WellGo

fxDischarge for Partially Penetrating Well given Correction FactorGo

Flow in Wells formulas that make use of Discharge for Partially Penetrating Well

fxCoefficient of Permeability given Discharge for Partially Penetrating WellGo

fxAquifer Thickness given Discharge for Partially Penetrating WellGo

fxThickness of Aquifer given Discharge for Partially Penetrating WellGo

fxDepth of Water in Well given Discharge for Partially Penetrating WellGo

fxRadius of Influence given Discharge for Partially Penetrating WellGo

fxRadius of Well given Discharge for Partially Penetrating WellGo

fxCorrection Factor for Partial Penetration given Discharge for Partially Penetrating WellGo

fxCorrection Factor for Partial Penetration given Discharge for Fully Penetrating WellGo

fxDischarge for Fully Penetrating Well given Correction FactorGo

List of variables in Flow in Wells formulas

fx Coefficient of Permeability Go

fx Aquifer Thickness Go

fx Initial Piezometric Surface Go

fx Depth of Water Go

fx Correction Factor Go

fx Radius of Influence Go

fx Radius of Well Go

fx Discharge for Fully Penetrating Gravity Well Go

FAQ

What is the Discharge for Partially Penetrating Well?

Discharge for Partially Penetrating Well refers to the volume of water extracted from an aquifer when the well does not extend through the entire thickness of the aquifer. Discharge for Partially Penetrating Well is usually measured using the Cubic Meter per Second for Volumetric Flow Rate. Note that the value of Discharge for Partially Penetrating Well is always positive.

Can the Discharge for Partially Penetrating Well be negative?

No, the Discharge for Partially Penetrating Well, measured in Volumetric Flow Rate cannot be negative.

What unit is used to measure Discharge for Partially Penetrating Well?

Discharge for Partially Penetrating Well is usually measured using the Cubic Meter per Second[m³/s] for Volumetric Flow Rate. Cubic Meter per Day[m³/s], Cubic Meter per Hour[m³/s], Cubic Meter per Minute[m³/s] are the few other units in which Discharge for Partially Penetrating Well can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!