Diameter1 in Stress and Strain Formulas

Diameter1 is the diameter on one side of the rod. And is denoted by d₁. Diameter1 is usually measured using the Meter for Length. Note that the value of Diameter1 is always negative.

Formulas to find Diameter1 in Stress and Strain

fxDiameter at Other End of Circular Tapering RodGo

Stress and Strain formulas that make use of Diameter1

fxLength of Circular Tapering Rod when deflection due to loadGo

fxElongation of Circular Tapering RodGo

fxLoad at End with known Extension of Circular Tapering RodGo

fxLength of Circular Tapering rodGo

fxDiameter at One End of Circular Tapering RodGo

fxModulus of Elasticity using Elongation of Circular Tapering RodGo

fxElongation of Truncated Conical Rod due to Self WeightGo

fxSpecific weight of Truncated Conical Rod using its elongation due to Self WeightGo

fxLength of Rod of Truncated Conical SectionGo

fxModulus of Elasticity of Rod using Extension of Truncated Conical Rod due to Self WeightGo

fxModulus of Elasticity of Bar with known elongation of Truncated Conical Rod due to Self WeightGo

List of variables in Stress and Strain formulas

fx Applied Load Go

fx Length Go

fx Young's Modulus Go

fx Elongation Go

fx Diameter2 Go

FAQ

What is the Diameter1?

Diameter1 is the diameter on one side of the rod. Diameter1 is usually measured using the Meter for Length. Note that the value of Diameter1 is always negative.

Can the Diameter1 be negative?

Yes, the Diameter1, measured in Length can be negative.

What unit is used to measure Diameter1?

Diameter1 is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Diameter1 can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!