FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Engineering
»
Production Engineering
»
Metal Machining
Diameter of Workpiece in Material Removed Formulas
The Diameter of Workpiece is the initial diameter of the workpiece before machining is done. This would be the diameter of the raw material stock that gets fed into the machine for processing. And is denoted by d
w
. Diameter of Workpiece is usually measured using the Millimeter for Length. Note that the value of Diameter of Workpiece is always positive.
Material Removed formulas that make use of Diameter of Workpiece
f
x
Metal removal rate given Diameter of workpiece
Go
f
x
Width of cut given Metal removal rate
Go
f
x
Feed speed given Metal removal rate
Go
f
x
Feed speed given workpiece and wheel removal parameter
Go
f
x
Machine infeed speed given workpiece and wheel removal parameter
Go
f
x
Wheel removal parameter given feed and machine infeed speed
Go
f
x
Workpiece removal parameter given feed and machine infeed speed
Go
FAQ
What is the Diameter of Workpiece?
The Diameter of Workpiece is the initial diameter of the workpiece before machining is done. This would be the diameter of the raw material stock that gets fed into the machine for processing. Diameter of Workpiece is usually measured using the Millimeter for Length. Note that the value of Diameter of Workpiece is always positive.
Can the Diameter of Workpiece be negative?
No, the Diameter of Workpiece, measured in Length cannot be negative.
What unit is used to measure Diameter of Workpiece?
Diameter of Workpiece is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Diameter of Workpiece can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!