Diameter of shaft at right end in Torsion of Shafts And Springs Formulas

Diameter of shaft at right end is the longer side diameter of tapering shaft. And is denoted by D₂. Diameter of shaft at right end is usually measured using the Millimeter for Length. Note that the value of Diameter of shaft at right end is always positive. Typically, the value of Diameter of shaft at right end is greater than 0.

Torsion of Shafts And Springs formulas that make use of Diameter of shaft at right end

fxTotal Angle of Twist for ShaftGo

fxTorque on Shaft given Total Angle of Twist for ShaftGo

fxModulus of Rigidity of Shaft given Total Angle of Twist for ShaftGo

fxLength of Shaft given Total Angle of Twist for ShaftGo

FAQ

What is the Diameter of shaft at right end?

Diameter of shaft at right end is the longer side diameter of tapering shaft. Diameter of shaft at right end is usually measured using the Millimeter for Length. Note that the value of Diameter of shaft at right end is always positive. Typically, the value of Diameter of shaft at right end is greater than 0.

Can the Diameter of shaft at right end be negative?

No, the Diameter of shaft at right end, measured in Length cannot be negative.

What unit is used to measure Diameter of shaft at right end?

Diameter of shaft at right end is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Diameter of shaft at right end can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!