FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Engineering
»
Civil
»
Hydraulics and Waterworks
Diameter of Section in Laminar Flow of Fluid in an Open Channel Formulas
The Diameter of Section refers to the length of the segment that passes through the center of the circle and touches two points on the edge of the circle. And is denoted by d
section
. Diameter of Section is usually measured using the Meter for Length. Note that the value of Diameter of Section is always positive.
Formulas to find Diameter of Section in Laminar Flow of Fluid in an Open Channel
f
x
Diameter of Section given Mean Velocity of Flow
Go
f
x
Diameter of Section given Discharge per Unit Channel Width
Go
f
x
Diameter of Section given Potential Head Drop
Go
f
x
Diameter of Section given Slope of Channel
Go
f
x
Diameter of Section given Bed Shear Stress
Go
Laminar Flow of Fluid in an Open Channel formulas that make use of Diameter of Section
f
x
Mean Velocity of Flow in Section
Go
f
x
Slope of Channel given Mean Velocity of Flow
Go
f
x
Dynamic Viscosity given Mean Velocity of Flow in Section
Go
f
x
Discharge per unit channel width
Go
f
x
Slope of Channel given Discharge per Unit Channel Width
Go
f
x
Dynamic Viscosity given Discharge per Unit Channel Width
Go
f
x
Potential Head Drop
Go
f
x
Length of Pipe given Potential Head Drop
Go
f
x
Shear Stress given Slope of Channel
Go
f
x
Slope of Channel given Shear Stress
Go
f
x
Bed Shear Stress
Go
f
x
Bed Slope given Bed Shear Stress
Go
List of variables in Laminar Flow of Fluid in an Open Channel formulas
f
x
Horizontal Distance
Go
f
x
Dynamic Viscosity
Go
f
x
Mean Velocity
Go
f
x
Slope of Surface of Constant Pressure
Go
f
x
Specific Weight of Liquid
Go
f
x
Kinematic Viscosity
Go
f
x
Slope of Bed
Go
f
x
Length of Pipe
Go
f
x
Head Loss due to Friction
Go
f
x
Shear Stress
Go
FAQ
What is the Diameter of Section?
The Diameter of Section refers to the length of the segment that passes through the center of the circle and touches two points on the edge of the circle. Diameter of Section is usually measured using the Meter for Length. Note that the value of Diameter of Section is always positive.
Can the Diameter of Section be negative?
No, the Diameter of Section, measured in Length cannot be negative.
What unit is used to measure Diameter of Section?
Diameter of Section is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Diameter of Section can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!