Diameter of Section in Geotechnical Engineering Formulas

Diameter of Section is the diameter of the circular cross-section of the beam. And is denoted by d_section. Diameter of Section is usually measured using the Meter for Length. Note that the value of Diameter of Section is always negative.

Formulas to find Diameter of Section in Geotechnical Engineering

fxDiameter of Circular Footing given Bearing CapacityGo

Geotechnical Engineering formulas that make use of Diameter of Section

fxBearing Capacity of Non Cohesive Soil for Circular FootingGo

fxEffective Surcharge given Bearing Capacity of Non Cohesive Soil for Circular FootingGo

fxBearing Capacity Factor Dependent on Surcharge for Circular FootingGo

fxBearing Capacity Factor Dependent on Unit Weight for Circular FootingGo

fxUnit Weight of Non Cohesive Soil given Bearing Capacity of Circular FootingGo

List of variables in Geotechnical Engineering formulas

fx Ultimate Bearing Capacity in Soil Go

fx Effective Surcharge in KiloPascal Go

fx Bearing Capacity Factor dependent on Surcharge Go

fx Bearing Capacity Factor dependent on Unit Weight Go

fx Unit Weight of Soil Go

FAQ

What is the Diameter of Section?

Diameter of Section is the diameter of the circular cross-section of the beam. Diameter of Section is usually measured using the Meter for Length. Note that the value of Diameter of Section is always negative.

Can the Diameter of Section be negative?

Yes, the Diameter of Section, measured in Length can be negative.

What unit is used to measure Diameter of Section?

Diameter of Section is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Diameter of Section can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!