Diameter of Driver in Belt, Rope and Chain Drives Formulas

The diameter of driver is a chord that runs through the center point of the circle. It is the longest possible chord of any circle. And is denoted by d_d. Diameter of Driver is usually measured using the Meter for Length. Note that the value of Diameter of Driver is always negative. Typically, the value of Diameter of Driver is greater than 0.

Belt, Rope and Chain Drives formulas that make use of Diameter of Driver

fxVelocity Ratio of Simple Belt Drive when Thickness ConsideredGo

fxVelocity Ratio of Simple Belt Drive when Thickness Not ConsideredGo

fxVelocity Ratio of Belt given Creep of BeltGo

fxVelocity Ratio of Belt given Total Percentage SlipGo

fxPeripheral Velocity of Driving PulleyGo

FAQ

What is the Diameter of Driver?

The diameter of driver is a chord that runs through the center point of the circle. It is the longest possible chord of any circle. Diameter of Driver is usually measured using the Meter for Length. Note that the value of Diameter of Driver is always negative. Typically, the value of Diameter of Driver is greater than 0.

Can the Diameter of Driver be negative?

Yes, the Diameter of Driver, measured in Length can be negative.

What unit is used to measure Diameter of Driver?

Diameter of Driver is usually measured using the Meter[m] for Length. Millimeter[m], Kilometer[m], Decimeter[m] are the few other units in which Diameter of Driver can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!