Development Length in Curtailment of Flexural Tension Reinforcement Formulas

Development Length is the amount of reinforcement or bar length needed to be embedded into the column to establish the desired bond strength between the concrete and steel. And is denoted by Ld. Development Length is usually measured using the Millimeter for Length. Note that the value of Development Length is always positive.

Formulas to find Development Length in Curtailment of Flexural Tension Reinforcement

fxBasic Development Length for Bars and Wire in TensionGo

fxBasic Development Length for 14mm Diameter BarsGo

fxBasic Development Length for 18mm Diameter BarsGo

fxDevelopment Length for simple SupportGo

Curtailment of Flexural Tension Reinforcement formulas that make use of Development Length

fxBar Steel Yield Strength given Basic Development LengthGo

fxComputed Flexural Strength given Development Length for Simple SupportGo

fxApplied Shear at Section for Development Length of Simple SupportGo

List of variables in Curtailment of Flexural Tension Reinforcement formulas

fx Area of Bar Go

fx Yield Strength of Steel Go

fx 28 Day Compressive Strength of Concrete Go

fx Computed Flexural Strength Go

fx Applied Shear at Section Go

fx Additional Embedment Length Go

FAQ

What is the Development Length?

Development Length is the amount of reinforcement or bar length needed to be embedded into the column to establish the desired bond strength between the concrete and steel. Development Length is usually measured using the Millimeter for Length. Note that the value of Development Length is always positive.

Can the Development Length be negative?

No, the Development Length, measured in Length cannot be negative.

What unit is used to measure Development Length?

Development Length is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Development Length can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!