Depth of Cutting at Centre in Quantity of Earthwork for Embankments Formulas

Depth of Cutting at Centre is the height of the bank at the center point of the cross-section of the road. And is denoted by d_center. Depth of Cutting at Centre is usually measured using the Millimeter for Length. Note that the value of Depth of Cutting at Centre is always positive. Typically, the value of Depth of Cutting at Centre is greater than 0.

Quantity of Earthwork for Embankments formulas that make use of Depth of Cutting at Centre

fxQuantity of Earthwork for Hilly Road Fully in Cutting or BankingGo

fxQuantity of Earthwork for Hilly Road Partially in BankingGo

fxQuantity of Earthwork for Hilly Road Partially in CuttingGo

FAQ

What is the Depth of Cutting at Centre?

Depth of Cutting at Centre is the height of the bank at the center point of the cross-section of the road. Depth of Cutting at Centre is usually measured using the Millimeter for Length. Note that the value of Depth of Cutting at Centre is always positive. Typically, the value of Depth of Cutting at Centre is greater than 0.

Can the Depth of Cutting at Centre be negative?

No, the Depth of Cutting at Centre, measured in Length cannot be negative.

What unit is used to measure Depth of Cutting at Centre?

Depth of Cutting at Centre is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Depth of Cutting at Centre can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!