FormulaDen logo
FormulaDen.com
Search
Physics Chemistry Math Chemical Engineering Civil Electrical Electronics Electronics and Instrumentation Materials Science Mechanical Production Engineering Financial Health

Density of Work Piece in Temperatures in Metal Cutting Formulas

Density of Work Piece is the mass per unit volume ratio of the material of workpiece. And is denoted by ρwp. Density of Work Piece is usually measured using the Kilogram per Cubic Meter for Density. Note that the value of Density of Work Piece is always positive.

Formulas to find Density of Work Piece in Temperatures in Metal Cutting

fxDensity of Material using Average Temperature Rise of material under Primary Shear Zone​Go

Temperatures in Metal Cutting formulas that make use of Density of Work Piece

fxRate of Heat Generated in Primary Shear Zone given Temperature Rise​Go
fxRate of Heat generated in Secondary Shear Zone given Average Temperature​Go
fxAverage Temperature Rise of Material under Primary Deformation Zone​Go
fxSpecific Heat given Average Temperature Rise of Material under Primary Shear Zone​Go
fxCutting Speed given Average Temperature Rise of Material under Primary Shear Zone​Go
fxUndeformed Chip Thickness given Average Temperature Rise of Material under Primary Shear Zone​Go
fxDepth of Cut given Average Temperature Rise of Material under Primary Shear Zone​Go
fxAverage Temperature rise of chip from Secondary Deformation​Go
fxSpecific Heat using Average Temperature Rise of Chip from Secondary Deformation​Go
fxCutting Speed using Average Temperature Rise of Chip from Secondary Deformation​Go
fxUn-deformed Chip Thickness using Average Temperature Rise of Chip from Secondary Deformation​Go
fxDepth of Cut using Average Temperature Rise of Chip from Secondary Deformation​Go

List of variables in Temperatures in Metal Cutting formulas

fx Fraction of Heat Conducted into The Workpiece ​Go
fx Rate of Heat Generation in Primary Shear Zone ​Go
fx Average Temperature Rise ​Go
fx Specific Heat Capacity of Workpiece ​Go
fx Cutting Speed ​Go
fx Undeformed Chip Thickness ​Go
fx Depth of Cut ​Go

FAQ

What is the Density of Work Piece?
Density of Work Piece is the mass per unit volume ratio of the material of workpiece. Density of Work Piece is usually measured using the Kilogram per Cubic Meter for Density. Note that the value of Density of Work Piece is always positive.
Can the Density of Work Piece be negative?
No, the Density of Work Piece, measured in Density cannot be negative.
What unit is used to measure Density of Work Piece?
Density of Work Piece is usually measured using the Kilogram per Cubic Meter[kg/m³] for Density. Kilogram per Cubic Centimeter[kg/m³], Gram per Cubic Meter[kg/m³], Gram per Cubic Centimeter[kg/m³] are the few other units in which Density of Work Piece can be measured.
About | Contact | Disclaimer | Terms | Privacy Policy
© 2024. Developed & Maintained by softUsvista Inc.
Copied!