Belt Pitch Line and Pulley Tip Circle Radius Width in Design of Belt Drives Formulas

Belt Pitch Line and Pulley Tip Circle Radius Width is the distance between the pitch line of belt (which is situated outside the pulley-tip-circle radius) and the pulley tip circle radius. And is denoted by a_p. Belt Pitch Line and Pulley Tip Circle Radius Width is usually measured using the Millimeter for Length. Note that the value of Belt Pitch Line and Pulley Tip Circle Radius Width is always positive.

Formulas to find Belt Pitch Line and Pulley Tip Circle Radius Width in Design of Belt Drives

fxDistance from Belt pitch line to Pulley tip circle radiusGo

Design of Belt Drives formulas that make use of Belt Pitch Line and Pulley Tip Circle Radius Width

fxPulley Pitch Diameter given Distance between Belt pitch line and Pulley tip circle radiusGo

fxPulley outside Diameter given Distance between Belt Pitch line and Pulley tip circle radiusGo

List of variables in Design of Belt Drives formulas

fx Pulley Pitch Diameter Go

fx Pulley Outside Diameter Go

FAQ

What is the Belt Pitch Line and Pulley Tip Circle Radius Width?

Belt Pitch Line and Pulley Tip Circle Radius Width is the distance between the pitch line of belt (which is situated outside the pulley-tip-circle radius) and the pulley tip circle radius. Belt Pitch Line and Pulley Tip Circle Radius Width is usually measured using the Millimeter for Length. Note that the value of Belt Pitch Line and Pulley Tip Circle Radius Width is always positive.

Can the Belt Pitch Line and Pulley Tip Circle Radius Width be negative?

No, the Belt Pitch Line and Pulley Tip Circle Radius Width, measured in Length cannot be negative.

What unit is used to measure Belt Pitch Line and Pulley Tip Circle Radius Width?

Belt Pitch Line and Pulley Tip Circle Radius Width is usually measured using the Millimeter[mm] for Length. Meter[mm], Kilometer[mm], Decimeter[mm] are the few other units in which Belt Pitch Line and Pulley Tip Circle Radius Width can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!