symbol.' />
symbol.' />
FormulaDen.com
Physics
Chemistry
Math
Chemical Engineering
Civil
Electrical
Electronics
Electronics and Instrumentation
Materials Science
Mechanical
Production Engineering
Financial
Health
You are here
-
Home
»
Engineering
»
Civil
»
Structural Engineering
Area of Compression Reinforcement in Analysis using Limit State Method Formulas
Area of Compression Reinforcement is the amount of steel required in the compression zone. And is denoted by A
s'
. Area of Compression Reinforcement is usually measured using the Square Millimeter for Area. Note that the value of Area of Compression Reinforcement is always positive.
Analysis using Limit State Method formulas that make use of Area of Compression Reinforcement
f
x
Bending Moment Capacity of Rectangular Beam
Go
f
x
Depth of Equivalent Rectangular Compressive Stress Distribution
Go
FAQ
What is the Area of Compression Reinforcement?
Area of Compression Reinforcement is the amount of steel required in the compression zone. Area of Compression Reinforcement is usually measured using the Square Millimeter for Area. Note that the value of Area of Compression Reinforcement is always positive.
Can the Area of Compression Reinforcement be negative?
No, the Area of Compression Reinforcement, measured in Area cannot be negative.
What unit is used to measure Area of Compression Reinforcement?
Area of Compression Reinforcement is usually measured using the Square Millimeter[mm²] for Area. Square Meter[mm²], Square Kilometer[mm²], Square Centimeter[mm²] are the few other units in which Area of Compression Reinforcement can be measured.
Let Others Know
✖
Facebook
Twitter
Reddit
LinkedIn
Email
WhatsApp
Copied!