Area of Choke Section of Sprue in Gating System For Casting Formulas

Area of Choke Section of Sprue is the area at that part of sprue where it runs full of metal. And is denoted by A_c. Area of Choke Section of Sprue is usually measured using the Square Centimeter for Area. Note that the value of Area of Choke Section of Sprue is always positive.

Formulas to find Area of Choke Section of Sprue in Gating System For Casting

fxChoke Area using Bernoulli's EquationGo

Gating System For Casting formulas that make use of Area of Choke Section of Sprue

fxPouring Time using Bernoulli's EquationGo

fxCasting Mass using Bernoulli's EquationGo

fxDensity of Molten Metal using Bernoulli's EquationGo

List of variables in Gating System For Casting formulas

fx Casting Mass Go

fx Density of Metal Go

fx Pouring Time Go

fx Efficiency Factor of Gating System Go

fx Effective Metal Head of Mould Go

FAQ

What is the Area of Choke Section of Sprue?

Area of Choke Section of Sprue is the area at that part of sprue where it runs full of metal. Area of Choke Section of Sprue is usually measured using the Square Centimeter for Area. Note that the value of Area of Choke Section of Sprue is always positive.

Can the Area of Choke Section of Sprue be negative?

No, the Area of Choke Section of Sprue, measured in Area cannot be negative.

What unit is used to measure Area of Choke Section of Sprue?

Area of Choke Section of Sprue is usually measured using the Square Centimeter[cm²] for Area. Square Meter[cm²], Square Kilometer[cm²], Square Millimeter[cm²] are the few other units in which Area of Choke Section of Sprue can be measured.

Let Others Know

✖

Facebook

Twitter

Copied!